|
 |
 |
 |
 |
Tuff Coat EP-101 Epoxy Paint
|
| |
| INTRODUCTION
|
|
|
Tuff Coats PU-101 Enamel is the two component system, designed to cross
link at room temperature. Base component is an acrylic polyurethane i.e. Hydroxyl Functional Acrylic copolymer
(pigmented) which reacts with blocked polyisocynate adduct (Second component) to form tough film with
outstanding durability, chemical & weather resistance. The system also gives excellent gloss and color retentions properties.
|
|
|
| THE RANGE OF APPLICATION :
|
|
|
An effective Top Coat for petrochemical refinery and fertilizer industries. The
system is useful for maintenance coating, structural coating as well as for floor coating. Because of rapid curing
at room temperature and excellent toughness and abrasion resistance, resistance to heat, oil, Alcohols Acid & salty
weather, the system gives wide range of application in Aircraft finishes, transport finishes and chemical industries.
|
|
|
|
|
| KEY PROPERTIS OF SYSTEM : |
| |
Fast drying at room temperature It can withstand to the temperature around 100 D.C. |
Weather
Resistance |
Excellent colour & gloss retention |
Alcohol
Resistance |
Unaffected by splash and spillage |
Salts |
Unaffected |
|
| |
|
Water
Resistance |
Excellent water & salty water resistance, ( not recommended for
immersion) |
|
|
| Oil &
Grease |
Unaffected |
|
| |
| APPLICATION : |
| |
Before application of Top-coat PU-101 Enamel do all necessary
pretreatment of the job. For M.S.surface remove grease oil & other contamiation by using proper de-rusting &
Phosphating chemicals to clean surface. Apply properly TUFF COAT PU-102
primer coat or Hi-Build wash primer. After proper drying of primer coat
apply PU-101 Enamel. For old concrete remove salt deposition / fungal growth, loosely bound
coatings, dust particles and make the surface rough. Also for new concrete do the needful pretreatment / priming and then
apply Top-Coat PU-101 Enamel. Stir the base component thoroughly & mix four parts of base &
one part of hardener by volume to uniform consistency. Keep it for 15-30 min for stabilization & stir again before use.
Make required viscosity as per application method with TC / PU 101 Thinner. Mix the above material as per requirement because
of 4-5 hrs. Pot life ; close the containers immediately to avoid the chances of the moisture absorption in material.
Do not apply in humid condition during the raining, fog or mist or at
very low temperature i.e. bellow 7oC |
| |
| STABILITY OF HARDENER - |
| |
| Once the hardener container is
opened ; try to consume it immediately because it reacts with Hydroxyl groups present in atmosphere & it results in to
gelatin. |
|
|
 |
| |
 |
 |
 |
|
